Shooters and musicians who use in-ear monitors (IEMs) face very different noise. A rifle shot is over in a few milliseconds but reaches extraordinary peak levels. A musician’s in-ear mix is far quieter at any instant but runs for hours. Both cause permanent hearing damage, and the protection that suits one is often wrong for the other.
How Australian exposure limits work
Australian work health and safety law sets two separate noise limits, and they map neatly onto these two groups. The first is an eight-hour average of 85 dB(A), written LAeq,8h. The second is a peak limit of 140 dB(C), written LC,peak, which applies to any single sound. Above 140 dB(C), damage can occur from one exposure.
The eight-hour limit uses a 3 dB exchange rate. Every 3 dB increase doubles the sound energy, so the allowable time halves.
| Average level | Time to reach the daily limit |
|---|---|
| 85 dB(A) | 8 hours |
| 88 dB(A) | 4 hours |
| 91 dB(A) | 2 hours |
| 94 dB(A) | 1 hour |
| 97 dB(A) | 30 minutes |
| 100 dB(A) | 15 minutes |
| 103 dB(A) | 7.5 minutes |
| 106 dB(A) | Under 4 minutes |
These workplace limits are designed to protect most people, not everyone. Treat them as a ceiling and aim well below them.
Shooting is a peak problem
Most firearms produce peak levels at the shooter’s ear of roughly 140 to 175 dB SPL, depending on calibre, barrel length and whether you are outdoors, indoors or under a covered firing line. Even a .22 rifle sits around the 140 dB peak limit. Indoors, or under a roof, reflections add further peaks and lengthen the exposure.
Impulse noise damages the cochlea differently from steady noise. The pressure wave can mechanically disrupt the delicate structures of the inner ear, including the outer hair cells and their stereocilia, instead of wearing them down gradually through metabolic stress. Animal research has also shown that noise can destroy the synapses between inner hair cells and the auditory nerve while leaving hearing thresholds normal, a finding explained in our article on hidden hearing loss.
The audiometric signature is a dip, or notch, between about 4,000 and 6,000 Hz. In right-handed rifle shooters the left ear is often worse, because it faces towards the muzzle while the right ear is partly shielded by the head and shoulder.
What works for shooting
- Insertion depth matters more than the rating. Foam plugs carry high laboratory ratings but only achieve them when rolled tightly, inserted deeply and held while they expand. A shallow insertion loses much of the protection. Our article on foam vs custom earplugs explains why fit is the variable that matters.
- Double up for large calibres and indoor ranges. Plugs under earmuffs protect better than either alone, but the gain isn’t additive. Expect roughly 5 to 10 dB more than the better single protector. Beyond that, sound reaches the cochlea through the skull itself, which caps total attenuation at around 40 to 50 dB.
- Electronic protection lets speech and range commands through at normal levels and limits louder sound. Good units respond within milliseconds and still provide passive attenuation when switched off. Check the passive rating, because that is what protects you when the electronics clip or the battery dies.
- Custom electronic plugs combine a moulded fit with level-dependent electronics. They suit people who shoot often or find that muffs interfere with a cheek weld.
Protectors sold in Australia are rated with an SLC80 value under AS/NZS 1270: the attenuation that 80% of wearers can expect when the protector is fitted correctly. The class system printed on the packet, from Class 1 to Class 5, is based on that number.
In-ear monitors are a dose problem
In-ear monitors seal the ear canal and deliver a personal mix straight to the eardrum. That isolation can protect hearing, because the performer no longer has to compete with loud wedges and backline. The risk comes when the mix is turned up to cut through stage noise leaking past a poor seal, or to match the energy of the room.
The levels are often higher than musicians realise. A mix averaging 100 dB at the eardrum uses a full day’s allowance in about 15 minutes. A three-hour rehearsal averaging 94 dB is three times the daily limit. Clean, undistorted sound doesn’t feel as loud as it is, which is part of why IEM levels creep up.
What works for IEM users
- Get the seal right first. Custom-moulded IEMs or well-fitted foam tips block more stage noise, so the mix can sit lower and stay clear. Impressions for custom IEMs are usually taken with the mouth open on a bite block, because jaw movement changes the shape of the ear canal and the seal has to hold while you sing.
- Use both ears. Taking one earpiece out to hear the room is common and risky. The open ear gets full stage volume, and the in-ear side is often turned up to compensate.
- Add a limiter. A limiter on the monitor feed caps sudden spikes such as feedback, a dropped microphone or a misrouted channel.
- Measure the actual level. The sound at your eardrum depends on the earpiece, the fit and the belt pack’s output. An audiologist can measure it in your ear with a probe microphone, the same equipment used to verify hearing aids, which turns a guess into a number you can manage.
Drummers have the hardest job, because the acoustic kit is loud whatever is in the mix. Drummers and hearing loss and musician and concert earplugs cover filtered plugs, which reduce all frequencies by a similar amount so the sound stays balanced.
Warning signs and baseline testing
Ringing, muffled hearing or a feeling of fullness after shooting or a gig means the exposure was enough to cause at least a temporary threshold shift, and repeated temporary shifts are linked with permanent damage. A baseline hearing test while your hearing is still normal, followed by periodic checks, can pick up an early notch at 4 kHz before you notice it in conversation. If you already have tinnitus or trouble hearing in noise, an assessment will show where you stand and help you choose protection that suits how you shoot or perform.





